Skip to content
FlooringMath
Menu

Paver Base Calculator

How much crushed gravel to order for the base under pavers, in cubic yards, tons or bags, with the right depth for a walkway, patio or driveway and the compaction allowance most calculators forget.

Units
1. Area to pave
  1. Net area: —

2. Use and depth

Suggested: 4" compacted for this use and soil.

3. Material and price

Order

Enter the paving area.

How to calculate paver base

base area = paving area grown by the extension on every side loose cu yd = base area (sq ft) × depth (in) ÷ 12 × (1 + compaction) ÷ 27 tons = cu yd × density (≈ 1.4 tons per cu yd)

Why grow the area? The edge pavers and the edge restraint spikes need solid base under them, not the sloping shoulder of the trench. Extending the base 6" (or the base depth) past the paving adds more than you might expect on small jobs: a 12 × 20 ft patio grows from 240 to 273 sq ft of base.

Why add for compaction? Delivered crushed stone is loose. A plate compactor squeezes out the air, so you need roughly 15–25% more loose stone than the finished compacted volume. Without this, a "4 inch" base ends up closer to 3.3".

Worked example

A 12 × 20 ft patio on clay (6" base), extended 6" each side: 13 × 21 = 273 sq ft × 6/12 = 136.5 cu ft compacted × 1.2 = 163.8 cu ft = 6.07 cu yd ≈ 8.49 tons. Dig 6" + 1" sand + 2 3/8" paver = 9 3/8" below the finished surface.

Base depth by use

UseWell-drained soilClay / wet soil
Walkway / garden path (foot traffic)4"6"
Patio (foot traffic, furniture, grill)4"6"
Residential driveway (cars)8"12"
Heavy vehicles (RV, trucks)12"16"

Compacted depths. Add about 2" in freeze-thaw climates. Compact in lifts of 2"–4"; a plate compactor cannot densify a thicker layer in one pass. The full explanation is in paver base depth: patio vs driveway.

Paver base for common sizes

Square areas, base extended 6" on every side, 20% compaction, 1.4 tons per cu yd.

Paving area4" base6" base8" base
50 sq ft0.97 cu yd · 1.4 t1.45 cu yd · 2 t1.93 cu yd · 2.7 t
100 sq ft1.79 cu yd · 2.5 t2.69 cu yd · 3.8 t3.59 cu yd · 5 t
150 sq ft2.6 cu yd · 3.6 t3.9 cu yd · 5.5 t5.2 cu yd · 7.3 t
200 sq ft3.4 cu yd · 4.8 t5.1 cu yd · 7.1 t6.79 cu yd · 9.5 t
300 sq ft4.97 cu yd · 7 t7.46 cu yd · 10.4 t9.94 cu yd · 13.9 t
400 sq ft6.53 cu yd · 9.1 t9.8 cu yd · 13.7 t13.07 cu yd · 18.3 t
500 sq ft8.08 cu yd · 11.3 t12.13 cu yd · 17 t16.17 cu yd · 22.6 t

Bulk yards usually sell in half or quarter cubic yards or by the ton, with a delivery fee. The "Order" figure is rounded up to the next 1/4 cu yd. Next: bedding and polymeric sand.

Frequently asked questions

How much paver base do I need?

Multiply the base area (the paving area plus about 6" on every side) by the compacted depth in feet, add 15–25% because crushed stone shrinks when compacted (we use 20%), and divide by 27 for cubic yards. Multiply cubic yards by about 1.4 for tons.

How deep should paver base be for a patio?

About 4" of compacted crushed stone on well-drained soil and 6" on clay or wet soil, plus 1" of bedding sand. In freezing climates add about 2". Driveways need 8"–12".

How many bags of paver base do I need?

A 0.5 cu ft bag (about 50 lb) covers 1.5 sq ft at 4" compacted once you allow for compaction, so bags only make sense for small walkways and repairs. For anything over about 50 sq ft, bulk delivery by the ton is cheaper and saves carrying a hundred bags.

How many tons of gravel are in a cubic yard?

Crushed stone base usually weighs 1.3–1.5 tons per cubic yard depending on the rock and the moisture; 1.4 is a fair planning figure. Concrete sand is about 1.35. Your quarry can give you the exact number for their product.

What gravel is used for paver base?

A dense-graded crushed stone with fines that compacts hard, sold as road base, crusher run, CA-6, QP, or 3/4" minus depending on the region. Rounded pea gravel does not lock together and is not a base. Open-graded clean stone (#57) is used only for permeable pavers.

Do I need landscape fabric under the paver base?

A woven geotextile between the soil and the base is recommended on clay and wet soils: it keeps the base from mixing into the subgrade. It is optional on sandy, well-drained ground. Overlap the rolls about 12".

Last reviewed November 22, 2026. How we check our math: About FlooringMath.